Citizen TSV-400GP, Инструкция по эксплуатации

Страница: 25 / 36

- 24 -
SNMP Community Settings
Read Comm1 Read community name 1 (single-byte
alphabetic characters, maximum 12 characters)
Default setting: public
Read Comm2 Read community name 2 (single-byte
alphabetic characters, maximum 12 characters)
Default setting: read
Read Comm3 Read community name 3 (single-byte
alphabetic characters, maximum 12 characters)
Default setting: (Blank)
SNMP Trap
Conditions for Trap Generation
The power is turned on.
Communication with the GPS antenna is not possible
24 hours have elapsed since the GPS antenna last received a signal, and the time
server has stopped operating
SNMP Trap Settings
□ Enable Trap1 Trap 1 enabled (check box
selected)/disabled (check box cleared)
Default setting:
Disabled
Receiver IP Address1
Notification destination IP address 1 Default setting:
0.0.0.0
Community1 Community name 1 (single-byte alphabetic
characters, maximum 12 characters)
Default setting:
(Blank)
□ Enable Trap2 Trap 2 enabled (check box
selected)/disabled (check box cleared)
Default setting:
Disabled
Receiver IP Address2
Notification destination IP address 2 Default setting:
0.0.0.0
Community2 Community name 2 (single-byte alphabetic
characters, maximum 12 characters)
Default setting:
(Blank)
To change the settings, click Save Config.
Reboot In Progress... is displayed, and the settings are saved. Open the screen again
by selecting SNMP Configuration in the menu, and check that the settings were
changed.
If ERROR is displayed, there is a problem in the input. Check again the characters and
number of characters that you used, and enter them correctly.