iDP-562 User’s Manual
CITIZEN
25
6 Paging designation and page length designation
ESC(1B)
C(43)
n
Input ESC C (1B, 43) at the top of the line and next input n, which are integers. With this code, the length
(number of line) per page can be set, and paging action is started, and the space of three lines are left at the both
top and bottom of the page, n should be:
14
≤
n
≤
120
Otherwise, it comes to 66. The paging can be released by ESC O (1B, 4F).
7 Form Feed
FF(0C)
With this code, paper feed goes on. If there is data in the buffer when this code is input, the printer dose form feed
after the printing. The top of form for the next page is made in accordance with the page length which was
specified with ESC C n.
Top of position of the page is determined when power is turned on or when page length is specified with ESC C n.
8 Canceling
CAN(18)
All the data input in one line prior to CAN are cleared entirely with this code.
9 Line Spacing Designation
ESC(1B)
1(31)
With this code, 2.75mm line spacing can be set for graphic print.
10 Standard Line Spacing Designation
ESC(1B)
2(32)
With this code, 5.5mm line spacing can be set.
11 Reverse Characters Command
DC4(14)
DATA
CR(0D)
This code is used to input reverse characters command. If DC4 code is detected again on the same line, this
command will be released.
It is possible to input DC4 code repeatedly on one line, completing one-line printing.