45
—
—
3.10 Adjusting the Paper Near-end Sensor
Change the settings of the paper near-end sensor to set the position at which the near-
end of the paper is detected.
1. Gently press the paper near-end sensor with your finger.
2. Keep the paper near-end sensor pressed as you move it left and right. The sensor posi-
tions are shown below for the various diameters of the paper roll used.
(Unit: mm)
Sensor position
Paper roll outer diameter when near-end
is detected
Exterior/ interior diameter of core of
paper roll used
1*
Approximately ø22.0
ø18/ø12
2
Approximately ø25.0
ø18/ø12
3
Approximately ø29.0
ø18/ø12
4
Approximately ø34.0
ø18/ø12
Notes:
*Sensor position when shipped from the factory. However, factory settings differ depending on the destination-
market.
CAUTION
The diameter of the roll of paper that is detected is an estimate. Some variations may occur
depending on the paper.
Paper near-end sensor
