Citizen CT-S300, Руководство пользователя

Страница: 26 / 133

— 22 —
5.2 Manual Setting of Memory Switch
Memory switches can be set manually or by a command.
For manual setting, refer to the next page.
The function of each memory switch is shown in the following table. (The
white-on-black characters are factory setting.)
Switch No. Setting 0 (OFF) 1 (ON)
Memory SW1-1 Power ON info Send Not send
Memory SW1-2 Buffer size 4 Kbytes 45 bytes
Memory SW1-3 Busy condition Full/Err Full
Memory SW1-4 Receive error Print “?” No Print
Memory SW1-5 CR mode Ignored LF
Memory SW1-6 Reserved Fixed
−
Memory SW1-7 DSR signal Invalid Valid
Memory SW1-8 Init signal Invalid Valid
Memory SW2-1 Reserved
−
Fixed
Memory SW2-2 Auto cutter Invalid Valid
Memory SW2-3 Spool print Invalid Valid
Memory SW2-4 Full col printing CBM EPSON
Memory SW2-5 Resume aft PE Next Top
Memory SW2-6 Paper width 80 mm 58 mm
Memory SW2-7 Reserved Fixed
−
Memory SW2-8 NPE Enabled Disabled
Memory SW3-1 Resume Cttr Err Feed S/W Command
Memory SW3-2 Resume Open Err Close Command
Memory SW3-3 Parallel 31 pin Valid Invalid
Memory SW3-4 Paper Normal Black mark
Memory SW3-5 Column number 48/32 42/30
Memory SW3-6 No use Fixed
−
Memory SW3-7 CBM1000 mode Invalid Valid
Memory SW3-8 Open w/printing Auto Manual
Memory SW4-1 Auto length Enabled Disabled
Memory SW4-2 BM sensor Front Back
Memory SW4-3 No use OFF Fixed
Memory SW4-4 No use OFF Fixed
Memory SW4-5 No use OFF Fixed
Memory SW4-6 No use OFF Fixed
Memory SW4-7 No use OFF Fixed
Memory SW4-8 No use OFF Fixed
EPSON is the trademark of Seiko Epson Corporation.