— 20 —
3.5 Adjusting Paper Adjust Guide
By changing the position of the paper adjust guide, narrower paper can be set.
The paper adjust guide is set to the factory to the position shown below.
●
For CT-P290/CT-P291: 58-mm wide paper roll
●
For CT-P292/CT-P293: 80-mm wide paper roll
1.
Open the front cover and loosen the screw that fixes
the paper adjust guide. The amount of loosening the
screw is a half turn of a screwdriver. Excessive loosening
the screw may result in detachment of screw.
2.
In order to secure the clearance between the paper roll
used and paper adjust guide, set a spacer (coin or the
like) with a diameter of 1 to 2 mm to the paper holder
located at the FEED switch side.
3.
With the paper adjust guide pressed to the edge of the
paper roll, position the paper adjust guide.
4.
Tighten the screw with a Phillips screwdriver to fix the
adjust guide while pressing and holding the paper adjust
guide not to get slanted. Excessive tightening may result
in breakage of the paper adjust guide.
5.
Remove the spacer and verify that there is a clearance
by moving the paper roll toward right and left.
CAUTION!
■
If you change the paper width, degradation of print quality, faulty paper feeding, shorter
life, or other phenomenon may occur in rare case. In this case, verify that there is no
fault in the use conditions of printing. Even if no improvement is achieved, return the
paper width to the value specified at the time of factory shipment.
■
If you change the paper width, paper-loading feature may be degraded.
spacer
