Citizen CSRA-09, Инструкция по эксплуатации

Страница: 17 / 23

16
2-4 Installation of Drain Hose
Put together the refrigerent pipe,drain hose and the connecting wire of indoor and outdoor units
etc.Wrap them with binding belt.
2-5 Arrangement of Pipes
The drain hose should be put below the refrigerant pipe (copper pipe)
Do not bend the drain hose or raise it.
Do not wrap the drain hose in tensile state.
Arrange the pipes can toward five directions such as back, right, down, left, and left-back etc.
Attention that the drain hose must be put below the copper pipe.
Bind the pipes with binding belt from the palce close to the elbow.
(The overlap of the binding belt should be 1/2 of the belt’s width.)
Bind the pipes at the 1cm place inside of the unit, if you arrange
the pipes from the left side.
2-6 Installation of Indoor Unit
Pass the pipes through the wall, hoist the unit on the installation plate, fix the lower part with
a hook.
3. Installation of Outdoor Unit
It should be installed on the rigid place. (Such as the concrete object.) If it was installed on
the brick wall, the thickness of the brick wall should no less than 10cm.
If there is vibration, please install the protective anti-vibration rubber spacer.
Do not set the unit on the ground directly, it should be installed on the stable bearer which is
strong enough to burden the unit, and the bear also should be firmly fixed with the expan-
sion screws.
In order to avoid trouble, please do not install the unit on the ground directly.
The inclination angle of the installation place should be no more than 5
°
.
Front
Left
Left back
Down
Back
Right
Cut off this part if arrange
pipes toward left side
1cm
Cut off this part when arrange
pipes to right side Cut off this part when arrange
pipes downward
Install the wall-through sheath at
suitable place
Wall-through sheath
Attention! Do not
raise the drain hose
Installation plate