Citizen CSRA-09, Инструкция по эксплуатации

Страница: 11 / 23

10
3-2 Pre-set Temperature Operation
3-3 Up and Down Air Direction Controlling
Press “MODE” button and select “cooling” or “heating” (Heat Pump Type)mode, then press the
temperature setting “
” or “ ” button once, the pre-set temperature will be raised or lowered
by 1 .
Press the air “DIRECTION” button, the ventilating door will act in turns as following:
If you need different static angle. Press “DIRECTION” button when the automatic up and
down louver move to the position you want. Note:
static up and down swing
change in turn
4. Operation of the Timer
In the mode of “cooling”or “dehumidifying” or “heating” (Heat Pump Type) press “TIMER” button
to select “timer off” or “timer on”, then press “-” or “+” to set the time you need.
The initial value of timer time is 1 hour.
The pre-setting time range is 1-18 hours.
In the timer state, press any key, will cancel the set time except the time setting “-” or “+”
buttons.
Note:
5. Running Mode
Press “MODE” button, select cooling mode.
Press pre-set temperature “
” “ ” buttons, set the temperature you need.
Press “SPEED” button, choose the fan speed you need.
Press “DIRECTION.” button choose the air direction you want.
Stop, press “ ” button.
Attention:
When it turns to the seasons not using air conditioner (before maintenance), keep
the indoor unit running more than half an hour (method: In cooling mode,set temperature at
30
).
Note: Running lamp turns from on to out indicates the room temperature has reached the
pre-set temperature.
5-1 Cooling
5-2 Dehumidifying
Press “MODE” button,choose dehumidifying mode.
Press “DIRECTION” button,choose the suitable air direction.
Stop,press “ ” button.
Note: 1. The dehumidifying method: Keep the outdoor unit running for 10 minutes, then keep rest
for 5 minutes,repeat in cycles, the fan speed of indoor unit should be at low speed.
2. The temperature can’t be pre-set when in dehumidifying mode.
5-3 Heating
Press “MODE” button, choose heating mode.
Press pre-set temperature “
” or “ ” buttons, set the temperature you need.
Press “SPEED” button, choose the fan speed you need.
Press “DIRECTION” button, choose the air direction you want.
Stop, press “ ” button.
Note:
The detailed directions of indicating lamps see 3-1.