Chapter 3 Adjustments
CLP-521, CLP-621 & CLP-631
3-2
3-1. Mechanical Adjustment
When the following part is replaced, perform cutter slit width adjustment explained here.
- Cutter Stand Plate
- Cut Guide 2 Plate (Adjustment is also necessary when it is reassembled.)
3-1-1. Cutter slit width adjustment
1. Using thickness gauges (0.9 mm and 1.0 mm), check the cutter slit width in the Cutter
Stand Unit.
1)
Be sure that the 0.9 mm thickness gauge can pass through the slit on both right and
left sides.
2) Be sure that the 1.0 mm thickness gauge cannot pass the slit on both sides.
2. If satisfactory results are not obtained, adjust the slit width as follows:
1)
Loosen (not remove) the two screws "A" on the back of Cutter Stand Unit.
2) Adjust the slit width while sliding the Cut Guide 2 Plate located in the lower part of
Cutter Stand Unit. (The Cut Guide 2 Plate moves vertically along the elongate holes
"B".)
3) Be sure that the 0.9 mm thickness gauge passes through the slit but the 1.0 mm
thickness gauge does not pass it through.
Note:
Perform this check on both sides of the slit to ensure the parallelism of the Cut
Guide 2 Plate against the Cut Guide 1 Plate.
4) Tighten the screws "A" to fasten the Cut Guide 2 Plate.
[Rear view of the Cutter Stand Unit]
A
B
Thickness Gauge
Plate, Cutter Stand
Plate, Cut Guide 1
Plate, Cut Guide 2
