Printer Adjustments
44
3
Sensor Adjustments and Calibration
Adjusting the Reflective sensor
The reflective sensor is selected1
11
With the reflective sensor selected, install the label media so
21
that it is between the platen roller and the media sensor1
Be careful that black mark and media gap do not pass the
media sensor.
Then close the damper arm and the printhead1
Black mark
Label
Liner media
Bottom sensor
If the Pause Key is pressed then released while the MENU key
31
is continually pressed, the sensor is automatically adjusted1
Sensor Cal Mode
Executing
When automatic adjustment stops normally, "Succeeded" is
41
displayed by the LCD1 If it stops abnormally (adjustment is
impossible), ERROR LED flashes and "Failed" is displayed on
the LCD1
Sensor Cal Mode
Succeeded
If the Cancel (STOP) key is pressed, the Printer completes
51
sensor adjustment and the printer restarts1