7
8. USING THE ALARM
The alarm tone sounds for about 15 seconds at the same time every day once it has been set
(ON). The alarm can be switched off when it is sounding by pressing any button.
[Alarm (ON) Display]
<Setting Procedure>
(1) Press button
M
to switch the watch to the alarm mode.
(2) Press button
B
to display the city for which the alarm is to be set.
(3) Pressing button
B
continuously for about 2 seconds causes the alarm to be switched ON
and the hours to flash.
(4) Press button
A
to correct the "hours". (Pressing button
A
continuously causes the display
to advance rapidly.)
(5) Press button
B
to cause the "minutes" to flash.
(6) Press button
A
to correct the "minutes".
(7) Press button
M
to return to the normal display.
* Since the alarm time is also based on a 12-hour display when the time mode is set
to a 12-hour display, pay attention to AM(A) and PM(P) when setting the alarm time.
* After the alarm has been set, the alarm time does not change even if the time mode
is set to daylight savings time.
* When none of the buttons are operated for about 2 minutes in the alarm correction
state, the watch automatically returns to the normal alarm display.
* When button
M
is pressed in the alarm correction state, the watch immediately
returns to the normal alarm display.
<Switching the Alarm ON and OFF>
The alarm is switched On and OF (Off) each time button
A
is pressed during the normal alarm
display. When the alarm is set to ON, the "
" mark lights on the digital display in each mode.
<Sound Monitor>
The alarm monitor tone sounds for as long as button
A
is pressed in the alarm mode.
City name
Alarm On mark
Alarm time
On or OF
