8
9. USING THE CHRONOGRAPH
The chronograph is able to measure and display time up to a maximum of 23 hours, 59 minutes
and 59.99 seconds in 1/100 second units. Following completion of measurement for 24 hours, the
chronograph returns to the reset display and stops. In addition, the chronograph is also able to
measure split time (intermediate elapsed time).
[Chronograph Reset Display]
<Measurement Procedure>
(1) Press button
M
to switch the watch to the chronograph mode.
(2) The chronograph starts when button
A
is pressed and stops when button
A
is pressed dur-
ing measurement. Starting and stopping is repeated each time button
A
is pressed.
(3) Pressing button
B
while the chronograph is stopped returns it to the reset display.
<Split Time Measurement Procedure>
The most recent split time is displayed for about 10 seconds whenever button
B
is pressed dur-
ing chronograph measurement. (The SPL mark flashes while split time is displayed.)
* Pressing button
M
during chronograph measurement allows the mode to be changed.
Chronograph measurement can be displayed in continuation from the time the mode was
switched by again returning to the chronograph mode. However, the chronograph returns
to the reset display when measurement exceeds 24 hours.
✩
Split time: The amount of time that has elapsed at some intermediate point from the starting
line.
Hours
Minutes, seconds
and 1/100 seconds
Measuremant
Stops
Split time
*1: Automatically returns to the
measurement state after 10 seconds.
*1
Starting line
Finish line
Split time
Split time
