5
5.
Operating the FOGMAX
TM
5.1
Selecting the Location
Secure a good location for the machine to rest solidly on the floor or suspended so
that the output of the machine will not be restricted. Make sure that your unit is pointed
in a direction that leaves an open area out in front and can travel 10ft (3m) without
restriction. Place the front of the machine away from direct contact with electrical
instruments and people. Close output is very hot and wet. Always allow plenty of air
circulation to allow the fog to expand, separate and enlarge.
5.2
Electrical Power Requirements
This machine requires a separate 120VAC/20Amp (or 230VAC/10Amp) circuit for
operation. The FogMax
TM
draws approximately 15 amps at 120 VAC and 8 amps at
230VAC. During FogMax
TM
operation this circuit should be dedicated to the FogMax
TM
.
If you have any doubts about the capacity or grounding of your existing circuits,
consult a qualified electrician.
5.3
Hooking things up
Plug the 5-pin XLR of the Remote Control to the inlet marked “Remote Control”. Fill
the bottle with CITC’s SmartFog Fluid. Place the filter end of the tube inside the
bottom of the bottle and tighten cap. Be sure the vent hole in the cap is not blocked.
5.4
Operating the machine with the remote
1.
Turn on the power switch on the fogger. Verify that the red light in the switch and the
red “power” LED on the remote both illuminate. Wait approximately 7-10 minutes for
the green "ready” light, located on the remote control, to come on.
2.
Using the "vary output" button, you may adjust the output volume with the volume
control. Using the “timer” button, you may adjust the "on" and "off" knobs for timing the
fog and the “output” knob. The amount of fog can be adjusted by using the volume
"output" knob. NOTE: Do not depress "vary output" when using timer. When using the
“blast” button, you will not have timer or volume output control. The "blast" button
provides maximum smoke as long as you hold the button down.
5.5
DMX Control
With DMX control, you will be able to adjust the fog levels on/off, from 0 – 100%. DMX
will override all remote control functions. Once your fogger is warm and the green
“ready” light is on, you may control the fog output from the control booth. (See section
5.9)
