4
3.
Description of the FogMax
TM
The FogMax
TM
w/DMX is CITC’s industry-proven fogging system. No other
comparable machine delivers a thicker, whiter output of 30,000 cfm (850m
3
/minute) of
digitally controlled fog. Extremely reliable, the FogMax
TM
can produce longer on high
than the stiffest competition. Accurate temp control makes shut down history. It now
has a quieter pump with a 1500 watt heating head, a 1-channel DMX on board, remote
control cycle-timer and hanging bracket. The FogMax™ is your best bet for
professional fog. Uses water-based CITC SmartFog™ fluid in 15 Minute, 1 Minute, 3
Minute, 25 Minute, 45 Minute or 60 Minute. The extra dry fog leaves no mess, no
residue and can be fully controlled with DMX.
The following sequence produces fog:
1. The fog generator is preheated for 5 – 10 minutes.
2. The pump is controlled from 0 – 100% output by the Remote Cycle-Timer
Controller or by DMX.
3. At 12 o’clock output, the unit will produce fog continuously without delay
4. At 100% output (3 o’clock on Volume Control), the unit will produce a heavy fog
for 30 minutes or more without delays. After a short rest period the FogMax™
is again warmed up and ready to produce fog.
4.
Safety instructions
WARNING: Read and understand all labels and operating
instructions before attempting installation.
o
Never open the machine without disconnecting power lead first!
Risk of electrical shock-
This device is supplied with a grounding conductor. To
reduce risk of electrical shock, connect only to properly grounded, grounding type
receptacles. Never remove the third prong from the plug.
o
This machine requires a 120VAC/20A circuit for operation (or a 230VAC/10A circuit for
the 230VAC machine). The FogMax
TM
draws approximately 15 amps at 120 VAC (8
amps at 230VAC). During FogMax
TM
operation this circuit should be dedicated to the
FogMax
TM
. If you have any doubts about the capacity or grounding of your existing
circuits, consult a qualified electrician.
o
Be sure area around fogger is dry before applying electrical power.
o
Make sure that your unit is pointed in a direction that leaves a 10ft (3m) open area out
in front. Place the front of the machine away from direct contact with electrical
instruments and people. Close output is very hot and wet.
o
Never operate the pump without fluid passing through the tube. Operating the pump
without fluid can cause damage that is not covered under warranty.
o
Fluid is very slippery when spilled. Care in keeping any drips or spills cleaned up is
necessary.
o
Do not store FogMax
TM
in freezing conditions.
