Cissell CSHW35-HW55-164, Инструкция по эксплуатации

Страница: 33 / 33

33
7
Clean the entire cabinet of the machine regularly and remove all traces of soap,
etc....
Remove all detergent residue in the soap dispenser with hot water.
Clean the door gasket and remove all detergents and other products.
Shut off the main water, steam and power connections at the end of each day.
Do not change the setting of the water inlet taps on boiler fed machines once
these have been installed.
It is recommended to leave the door and the soap dispenser open after use, to
ventilate the machine.
p
General maintenance
p
p
p
p
Maintenance of the machine
The V-belts of the motors should be retightened after two to three months when
first used. This is necessary because these belts are subject to a one-time
stretching when first used. By ignoring this instruction , the belt starts to slip
after a few months and will brake shortly afterwards.
Check regularly if the filters of the water inlet are not blocked by calcification.
If a machine frequently skips the final spin, check whether the probe of the out
of balance switch is still in the appropriate position, that is horizontally
centered and vertically 1/3 from the bottom inside the window. (When the drum
is empty). (See electronic repetition system).
An obstructed drain can cause frequent interruption of spinning for safety
reasons.
p
Periodical maintenance
p
p
p
In case of important malfunctions and deficiencies which you cannot resolve
yourself, do not hesitate to contact the technical service of your distributor.
Repair and after-sales
service
p
The manufacturer reserves the right to change the content of this instruc-
tion manual, at all times and without previous notice.
Data machine:
Type:.....................................................................................
Program: ...............................................................................
Date of installation: ...............................................................
Installed by: ..........................................................................
Serial number: .......................................................................
Operation voltage and frequency: ..........................................
Data distributor:
Name: ...................................................................................
Address: ...............................................................................
Tel.: ......................................................................................