Cisco WS-SVC-WISM2-1-K9, Инструкция по установке и проверке

Страница: 6 / 16

6
Catalyst 6500 Series Wireless Services Module 2 Installation and Verification Note
78-16318-01
Note The USB console driver also works on Linux and MacOS Hosts. See the notes listed inside the
Cisco Windows USB Console driver package for installation details.
There is an LED adjacent to the USB CONSOLE connector and an LED next to the RJ-45 CONSOLE
connector. One of these two LEDs will light to indicate the active console. For LED information see the
“Status LEDs” section on page 3 . Both ports are described in this section.
Figure 2 USB CONSOLE Port and RJ-45 CONSOLE Port
RJ-45 CONSOLE Port
The RJ-45 CONSOLE port is used for the initial configuration of the WiSM2. The port is a single RS232
port used for customer console port access and is connected to the control plane UART serial interface.
The console port pinouts on the RJ-45 connector, is shown in
Table 3 . At initial power-up, the software
should set the default baud rate to 9600.
Table 3 Console RJ-45 Port Pinouts
CLEI
CONSOLE
282220
USB
CONSOLE
Port
RJ-45
CONSOLE
Port
Pin Number
Console/Aux Port (RJ-45)
Signal Direction
1 NC
2 TXD-DBG Output
3 TXD Output
4 GND
5 GND