Cisco WS-SVC-WISM2-1-K9, Инструкция по установке и проверке

Страница: 15 / 16

15
Catalyst 6500 Series Wireless Services Module 2 Installation and Verification Note
78-16318-01
To remove the WiSM2, perform these steps:
Step 1
Shut down the module by one of these methods:
• In privileged mode from the router prompt, enter the hw-mod module mod shutdown command.
Note If you enter this command to shut down the module, you must enter the following commands
in global configuration mode to restart (power down, and then power up) the module:
Router# no power enable module mod
Router# power enable module mod
• If the module does not respond to any commands, press the SHUTDOWN button located on the front
panel of the module.
Note
Shutdown may require several minutes.
Step 2
Verify that the WiSM2 shuts down. Do not remove the module from the switch until the POWER LED
is off.
Step 3
Use a screwdriver to loosen the captive installation screws at the left and right sides of the module.
Step 4
Grasp the left and right ejector levers. Simultaneously, pull the left lever to the left and the right lever to
the right to release the module from the backplane connector.
Step 5
As you pull the module out of the slot, place one hand under the carrier to support it. Avoid touching the
module itself.
Step 6
Carefully pull the module straight out of the slot, keeping one hand under the carrier to guide it. Keep
the module at a 90-degree orientation to the backplane (horizontal to the floor).
Step 7
Place the removed module on an antistatic mat or antistatic foam.
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement
1029
Step 8
If the slot is to remain empty, install a module filler plate to keep dust out of the chassis and to maintain
proper airflow through the module compartment.