5-6
Cisco Cable Wideband Solution Design and Implementation Guide, Release 1.0
OL-10705-02
Chapter 5 Monitoring and Troubleshooting Wideband Components
Monitoring Wideband Components
Bit Rate: 1300 Mbps
50 micron-multimode fiber supported length: 550 m
62.5 micron-multimode fiber supported length: 270 m
Upper bit rate limit: not specified
Lower bit rate limit: not specified
Date code (yy/mm/dd): 05/02/23
Vendor name: CISCO-AGILENT
Vendor OUI: 12499
Vendor Part Number (PN): QFBR-5766LP Vendor Rev:
Vendor SN (SN): AGS090855CE
Options implemented:
LOS Signal
TX Fault Signal
TX Disable Signal
Enhanced options implemented: none
Diagnostic monitoring implemented: none
Idprom contents (hex):
0x00: 03 04 07 00 00 00 01 00 00 00 00 01 0D 00 00 00
0x10: 37 1B 00 00 43 49 53 43 4F 2D 41 47 49 4C 45 4E
0x20: 54 20 20 20 00 00 30 D3 51 46 42 52 2D 35 37 36
0x30: 36 4C 50 20 20 20 20 20 20 20 20 20 03 52 00 B5
0x40: 00 1A 00 00 41 47 53 30 39 30 38 35 35 43 45 20
0x50: 20 20 20 20 30 35 30 32 32 33 20 20 00 00 00 C4
0x60: 00 00 06 C9 F0 FA 7C 01 B3 C8 41 6B 39 04 FC 85
0x70: BB 20 9E 00 00 00 00 00 00 00 00 00 B4 94 52 CC
0x80: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x90: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
State: Initalized
Phased Initialization
Phase Reached: 4
Phase Exit Code: 0
Phase Read Offset: 0
...
Monitoring Wideband Channels
The following commands are useful for monitoring wideband channels:
•
show interface wideband-cable
•
show hw-module bay
show interface wideband-cable
To display information about a wideband-cable interface (wideband channel), use the
show interface
wideband-cable
command. Wideband channels are similar to cable interfaces and information about
them is also displayed with the
show ip interfaces
and
show interfaces
commands.
