Cisco WAP150 Quick Start Guide
3
Cisco WAP150 Features
Front Panel
The front panel of the Cisco WAP150 consists of one system LED. For full
descriptions of the colors of the lights and their indications, see
Verifying
the Hardware Installation
.
Back Panel
RESET
—See
Rebooting the Cisco WAP150 or Resetting to Factory
Defaults
for information on the RESET button.
LAN (PoE)
—The RJ-45 Ethernet port is used to power the Cisco WAP150
using PoE. It is an auto-sensing, Gigabit Ethernet (802.3) port used to
connect the Cisco WAP150 to network devices, such as computers,
routers, or switches. We strongly recommend that you use a Category
5e or better cable for Gigabit connectivity.
POWER
—The POWER button is used to turn the power on and off. It is not
applicable when using PoE.
12V DC
—The 12V DC jack is used to connect the supplied power adapter
to the Cisco WAP150 if you are not using PoE.
Kensington Lock Slot
—The Kensington lock slot is used to attach a cable
and lock to the Cisco WAP150.
Default Settings
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Mounting the Cisco WAP150
There are two ways to physically install the Cisco WAP150:
Parameter
Default Value
Username
cisco
Password
cisco
LAN IP Address
DHCP address assigned by server
Fallback LAN IP
192.168.1.245
Subnetwork Mask
255.255.255.0
2
3
