8
Cisco WAP150 Quick Start Guide
We strongly recommend that you use the Setup Wizard for the first
installation. For more advanced configurations, see the
Administration Guide. A link to the Administration Guide is found in
Where to Go From Here
.
Congratulations, you can now start using your Cisco WAP150.
Suggested Next Steps
In case of an error while installing, try the troubleshooting procedures
described in this section.
Troubleshooting
If you cannot display the configuration utility, you can test the ability of the
computer to communicate with the Cisco WAP150 by using
ping
. To use
ping
on a computer running Windows:
S
TEP
1
Verify that the Cisco WAP150 is powered on and the lights indicate
the appropriate links.
S
TEP
2
Locate the Cisco WAP150’s IP address. While there are different
ways to locate the IP address, this procedure uses Cisco FindIT.
a.
If you have previously downloaded Cisco FindIT, open Internet
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see
www.cisco.com/go/findit
.
b. In the Cisco FindIT display, place your mouse over the Cisco
WAP150’s name. The Cisco WAP150’s IP address is displayed
along with other device information.
S
TEP
3
Open a command window by choosing
Start
>
Run
and enter
cmd
.
S
TEP
4
At the
command
window prompt, enter
ping
and the Cisco
WAP150’s IP address. In this example, we pinged
192.0.2.10
.
If successful, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128
If it fails, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
7
