Cisco Unified MeetingPlace Web Conferencing, Руководство по установке и обновлению

Страница: 31 / 72

2-7
Installation and Upgrade Guide for Cisco Unified MeetingPlace Web Conferencing Release 6.x
OL-13418-01
Chapter 2 Installing Web Conferencing
Installation Tasks: Web Conferencing
To Configure a Single NIC with Both IP Addresses on the Cisco MCS Server
Step 1
Follow the procedure for “Configuring Network Settings” in the post-installation tasks in Installing the
Operating System on the Cisco Unified Communications Server (version 2003.1.1 or later). In this
procedure, configure the primary NIC on the system with a static IP address and with DNS, WINS, or
the LMHosts file for hostname resolution.
Step 2
Add the secondary IP address to the primary NIC:
a.
On the Start menu, click Settings > Network Connections .
b. Right-click Local Area Connection , then click Properties .
c.
Double-click Internet Protocol (TCP/IP) .
d.
Click Advanced .
e.
On the IP Settings tab, in the IP Addresses area, click Add .
f.
Enter the secondary IP address and subnet mask and click Add .
g.
Click OK three times to close the Local Area Connection Properties window.
Step 3 (Optional) Continue performing the post-installation tasks in Installing the Operating System on the
Cisco Unified Communications Server (version 2003.1.1 or later).
Both NICs enabled, teamed, configured in Transmit
Load Balancing (TLB) mode
•
The two NICs act together to handle traffic
for both IP addresses; one NIC receives
inbound traffic, both NICs send outbound
traffic.
• If either NIC fails, the other NIC can take
over.
•
We strongly recommend this configuration if
the Web Conferencing server is connected to
a 100 MB/sec. network.
• This configuration is available only for HP
MCS server models.
•
To configure this option, perform the “To
Configure NIC Teaming on the Cisco MCS
Server (HP Models Only)” procedure on
page 2-8
Both NICs enabled, teamed, configured in Network
Fault Tolerance (NFT) mode • One NIC is active, handling traffic for both IP
addresses.
•
The other NIC is passive and takes over if the
primary NIC fails.
•
This configuration is available only for HP
MCS server models.
•
To configure this option, perform the “To
Configure NIC Teaming on the Cisco MCS
Server (HP Models Only)” procedure on
page 2-8