Cisco UCS C460, Инструкция по установке и обслуживанию

Страница: 23 / 106

2-5
Cisco UCS C460 Server Installation and Service Guide
OL-22326-01
Chapter 2 Installing the Server
Installing the Server In a Rack
Installing the Server In a Rack
The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and then scroll to
Technical Specifications :
http://www.cisco.com/en/US/products/ps10493/products_data_sheets_list.html
This section describes how to install the server in a rack.
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:

This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component
at the bottom of the rack.

If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
Statement 1006
Step 1
Install the slide rail assemblies in the rack. See Figure 2-2 .
a. Place the slide-rail assembly (item 3) against the inside of the front and rear rack posts (item 1), with
the slide rail facing the inside of the rack and the front mounting pegs in front of the front rack-post
holes (item 4).
b.
Expand the slide rail assembly toward the rear of the rack, until the rear mounting pegs seat in the
rear rack-post holes (item 2).
c. Compress the slide-rail assembly until the mounting pegs are fully seated and the locking clips at
both ends of the assembly lock.
Figure 2-2 Installing the Slide Rail Assemblies in the Rack
d. Attach the second slide-rail assembly to the opposite side of the rack.
1 Rack posts 2 Rear mounting pegs and locking clip
3
Slide rail assembly
4
Front mounting pegs and locking clip
3
1 1
2 4
198153