D14635.13 Profile C90 and Codec C90 Administrator Guide TC7.0, DECEMBER 2013.
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
112
Cisco TelePresence System Codec C90 and Profile 65” Dual using C90
Administrator Guide
Video SelfviewDefault PIPPosition
Determine the position on screen of the small self-view picture-in-picture (PiP) after a call. The
setting only takes effect when self-view is switched on (see the Video SelfviewDefault Mode
setting) and fullscreen view is switched off (see the Video SelfviewDefault FullscreenMode
setting).
Requires user role:
ADMIN
Value space:
<Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/LowerLeft/
LowerRight >
Current:
The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft:
The self-view PiP will appear in the upper left corner of the screen.
UpperCenter:
The self-view PiP will appear in the upper center position.
UpperRight:
The self-view PiP will appear in the upper right corner of the screen.
CenterLeft:
The self-view PiP will appear in the center left position.
CentreRight:
The self-view PiP will appear in the center right position.
LowerLeft:
The self-view PiP will appear in the lower left corner of the screen.
LowerRight:
The self-view PiP will appear in the lower right corner of the screen.
Example:
Video SelfviewDefault PIPPosition: Current
Video SelfviewDefault OnMonitorRole
Determine which monitor/output to display the main video source (self-view) on after a call.
The value reflects the monitor roles set for the different outputs in the Video Output HDMI/DVI/
Composite MonitorRole settings.
The setting applies both when self-view is displayed in full screen, and when it is displayed as
picture-in-picture (PiP), but only if the Video Monitors setting is set to Dual or Quadruple.
Requires user role:
ADMIN
Value space:
<First/Second/Third/Fourth/Current>
First:
The self-view picture will be shown on outputs with the Video Output HDMI/DVI/
Composite MonitorRole set to First.
Second:
The self-view picture will be shown on outputs with the Video Output HDMI/DVI/
Composite MonitorRole set to Second.
Third:
The self-view picture will be shown on outputs with the Video Output HDMI/DVI/
Composite MonitorRole set to Third.
Fourth:
The self-view picture will be shown on outputs with the Video Output HDMI/DVI/
Composite MonitorRole set to Fourth.
Current:
When leaving the call, the self-view picture will be kept on the same output as
during the call.
Example:
Video SelfviewDefault OnMonitorRole: Current
Video Monitors
Set the monitor layout mode.
Requires user role:
ADMIN
Value space:
<Single/Dual/DualPresentationOnly/Quadruple>
Single:
The same layout is shown on all monitors.
Dual:
The layout is distributed on two monitors.
DualPresentationOnly:
All participants in the call will be shown on the first monitor, while the
presentation (if any) will be shown on the second monitor.
Quadruple:
The layout is distributed on four monitors, so that each remote participant and
the presentation will be shown on separate monitors.
Example:
Video Monitors: Single
Contents
Introduction
Web interface
System settings
Setting passwords
Appendices
System settings
