l
eth2
l
port channel containing
eth2
and
eth3
You must assign non-routable IP addresses from the
169.254.42.0/24
CIDR block.
Before You Begin
l
See
the Stealthwatch specification sheet for your appliance
for information on
the
eth2
and
eth3
SFP+ ports. Note that
eth2
and
eth3
depend on how you
configure
eth0
.
l
If you are in First Time Setup, System Configuration displays the
eth2
or
eth2/eth3
port channel configuration after you finish configuring the appliance's
eth0
management information. Skip to step 3.
Procedure
1.
From the System Configuration menu, select
Network
, and then press
Enter
.
2.
Select
Node Communications
, and then press Enter.
3.
Select the inter-Data Node communication port configuration. You have the
following options:
l
Select
Yes
to aggregate
eth2
and
eth3
as a port channel for inter-Data
Node communications.
l
Select
No
to use
eth2
for inter-Data Node communications.
4.
Enter a non-routable
IP address
from the
169.254.42.0/24
CIDR block for
eth2
or the
eth2/eth3
port channel.
5.
Enter a
Netmask
of
255.255.255.0
for this IP address.
6.
Enter a
Gateway
address for this IP address.
7.
Enter a
Broadcast
address for this IP address.
8.
Select
Select
, then select
Yes
to confirm your entries.
This is the last configuration option in First Time Setup. Your appliance restarts
and implements the changes. On completion, the Login page opens.
What to Do Next
l
Change user passwords. See
Changing the Sysadmin User Password
for more
information.
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved.
- 81 -
Appendix B. Stealthwatch Hardware Installation
