4-22
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
OL-3526-05
Chapter 4 Configuring Unchannelized mode for the Cisco PA-MC-2T3+
Checking the Configuration
[biff-mc2t3h 293]
7513_1 uptime is 4 days, 6 hours, 11 minutes
System returned to ROM by reload
cisco RSP2 (R4700) processor with 131072K/2072K bytes of memory.
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0
Last reset from power-on
G.703/E1 software, Version 1.0.
G.703/JT2 software, Version 1.0.
Channelized E1, Version 1.0.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Bridging software.
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.1.
Chassis Interface.
1 EIP controller (4 Ethernet).
1 HIP controller (1 HSSI).
1 FSIP controller (8 Serial).
1 AIP controller (1 ATM).
1 TRIP controller (4 Token Ring).
1 FIP controller (1 FDDI).
2 VIP2 R5K controllers (2 E1)(2 Channelized T3).
4 Ethernet/IEEE 802.3 interface(s)
4 Token Ring/IEEE 802.5 interface(s)
66 Serial network interface(s)
1 HSSI network interface(s)
1 FDDI network interface(s)
1 ATM network interface(s)
2 Channelized T3 port(s)
123K bytes of non-volatile configuration memory.
16384K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
16384K bytes of Flash PCMCIA card at slot 1 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
No slave installed in slot 7.
Configuration register is 0x0
Using the show diag Command
Display the types of port adapters installed in your system (and specific information about each) using
the
show diag
slot
command, where
slot
is the
port adapter slot
in a Cisco 7100 series router, Cisco 7200
series router, Cisco 7301 router, and Cisco 7401ASR router and the
interface processor slot
in a Cisco
7000 series router or Cisco 7500 series router with a VIP. In the Cisco 7304 PCI Port Adapter Carrier
Card in a Cisco 7304 router,
slot
is the router
module-slot-number.
The following examples show output
for some of the supported platforms.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Cisco 7200 Series Routers
Following is an example of the
show diag
slot
command that shows a PA-MC-2T3+ in port adapter slot
5 of a Cisco 7200 series router:
The example that follows is for a port adapter in slot 5 of the Cisco 7200 router series:
Router#
show diag 5
