© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 19 of 41
Save the changes by exiting the BIOS; then reboot the server to enable the changes. FCoE capabilities are
enabled at this time. Verify that the latest FCoE drivers and firmware are loaded for the respective operating
system. The latest versions can be obtained from the HP Support website. The FCoE drivers are separate from the
Ethernet NIC drivers. Figure 5 shows the ports configured for FCoE and the drivers loaded.
Figure 5.
OneCommand FCoE Utility Showing Ports Configured for FCoE with Drivers Loaded
Configuring the Cisco Nexus 5000 Series and B22HP for FCoE
This example assumes that a server in bay 2 is using IOM 3 and 4 for FCoE connectivity.
1. Enable the FCoE feature on the Cisco Nexus 5000 Series Switch.
N5548-Bottom # config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# feature fcoe
FC license checked out successfully
fc_plugin extracted successfully
FC plugin loaded successfully
FCoE manager enabled successfully
FC enabled on all modules successfully
Warning: Ensure class-fcoe is included in qos policy-maps of all types
N5548-Bottom (config)#
N5548-Top # config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# feature fcoe
FC license checked out successfully
fc_plugin extracted successfully
