Cisco Nexus 3548 series, Справочник по командам

Страница: 220 / 556

200
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
ip rip metric-offset
ip rip metric-offset
To add an additional value to the incoming IP Routing Information Protocol (RIP) route metric for an
interface, use the
ip rip metric-offset command. To return the metric to its default value, use the no form
of this command.
ip rip metric-offset value
no ip rip metric-offset
Syntax Description
Command Default value: 1
Command Modes Interface configuration mode
Command History
Usage Guidelines This command allows you to add a fixed offset to the route metric of all incoming routes on an interface.
For example, if you set the metric-offset to 5 on an interface and the incoming route metric is 5, then
Cisco NX-OS adds the route to the route table with a metric of 10.
This command does not require a license but if you want to enable Layer 3 interfaces, you must install
the LAN Base Services license.
Examples
This example shows how to configure a metric offset of 10 for all incoming RIP routes on Ethernet
interface 2/1:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# no switchport
switch(config-if)# ip rip metric-offset 10
switch(config-if)#
Related Commands
value Value to add to the incoming route metric for an interface. The range is from
1 to 15. The default is 1.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
ip rip offset-list Adds an offset value to incoming RIP route metrics.