4-2
Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide
OL-29233-01
Chapter 4
Steps
Step 1
Using the drill hole template, mark the pilot holes on the floor at the identified locations.
Step 2
Remove the drill hole template, and drill the indicated anchor bolt holes into the floor at the pilot hole
locations.
Step 3
If an alternate floor mounting pattern is required, remove the lower side panels (left and right sides of
the chassis) to expose additional floor mounting holes (
Figure 4-1
).
Figure 4-1
Remove Lower Side Panels to Expose Additional Floor Mounting Holes
304215
