Cisco NCS 4000 Series, Руководство по установке оборудования

Страница: 45 / 82

• If you are inserting the card into the lower card cage in NCS 4016, the arrows on the OIR buttons should
be facing down.
If the card does not slide easily into the slot, the orientation may be wrong or the slot is not for the card.
Reorient the card, if necessary.
Step 4 Use both hands while inserting the card. Use one hand on the faceplate and the other hand along the base of
the card to guide it into a slot.
Alignment grooves exist on each slot in the card cage. When you install a card in the card cage,
make sure that you align both edges of the card carrier in the slot grooves.
Note
Step 5 Press the OIR buttons to unlock the ejector lever or levers.
Step 6
Make sure that the ejector lever or levers are oriented properly as the card slides into the slot. Carefully slide
the card into the slot until the ejector levers engage the catches, and then
stop.
Step 7
Simultaneously pivot the ejector lever or levers toward the faceplate of the card. Do not force the card; the
ejector lever or levers properly seat the card against the backplane.
If the captive screws are difficult to tighten, ensure that the ejector lever is properly secured to the
catch and that the card is properly seated in the slot. Note
Step 8 Use a number-2 Phillips screwdriver to tighten the captive screw or screws next to each card ejector lever to
ensure proper EMI shielding and prevent the card from becoming partially dislodged from the backplane.
Tighten the captive screws using 10.60 pound/force (lbf) inch (1.20 Nm torque).
Step 9 Before attaching the vertical cable management bracket, ensure that the card has been installed properly.
This bracket is not available for FCs (NCS 4009) and RPs (NCS 4009 and NCS 4016). Note
Step 10
Attach the vertical cable management bracket to the faceplate of the card using the two screws that came with
it. Tighten the screws using 5 to 6.8 pound/force (lbf) inch (0.65 Nm torque). The dark gray arm should be
facing down and the light gray arm should be facing up in the upper card cage of NCS 4016 or in NCS 4009.
The dark gray arm should be facing up and the light gray arm should be facing down in the lower card cage
of NCS 4016. See the following figure.
Hardware Installation Guide for the Cisco NCS 4000 Series
43
Installing Route Processor Cards, Fabric Cards, and Line Cards
Installing a Route Processor, Fabric Card, or Line Card