Cisco MWR 1941-DC - 1941 Mobile Wireless Router, Руководство по настройке программного обеспечения

Страница: 79 / 184

4-29
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
78-13983-08
Chapter 4 Configuring the MWR 1941-DC in an IP-RAN
Monitoring and Managing the MWR 1941-DC
Step 6
Enter the following commands to specify the public and private SNMP community names:
Router(config)# snmp-server community public RO
Router(config)#
snmp-server community
private
RW
Step 7 Enter the following command to enable the sending of SNMP traps:
Router(config)# snmp-server enable traps
Step 8
Enter the following command to specify the loopback interface from which SNMP traps should
originate:
Router(config)# snmp-server trap-source loopback number
Where number is the number of the loopback interface you configured for the O&M in Step 3 .
Step 9
At the configuration prompt, press Ctrl-Z to exit configuration mode.
Step 10 Write the new configuration to nonvolatile memory as follows:
Router# copy running-config startup-config
Show Commands for Monitoring the MWR 1941-DC
To monitor and maintain the MWR 1941-DC router (including the multilink, VWIC, and FE interfaces)
and to view information about the PPP mux and header compression configuration, use the following
commands:
Command Purpose
show ip rtp header-compression Displays RTP header compression statistics.
show interface fastethernet slot / port Displays the status of the FE interface.
show ppp multilink Displays MLP and multilink bundle information.
show ppp multilink interface number Displays multilink information for the specified
interface.
show ppp mux interface interface Displays statistics for PPP frames that have passed
through a given multilink interface.
show controllers fastethernet slot / port Displays information about initialization block,
transmit ring, receive ring and errors for the Fast
Ethernet controller chip.
show controllers t1 Displays information about the cable length, framing,
firmware, and errors associated with the T1. With the
MWR 1941-DC, this command also displays the
status of the relays on the VWIC.
show redundancy Displays current redundant setting and recent
changes in state.
show standby Displays HSRP configuration information.
clear counters fastethernet slot / port Clears interface counters.
clear ppp mux interface Clears the PPP mux counters on the specified
interface.
clear ip rtp header-compression Clears RTP header compression structures and
statistics.