Cisco MWR 1941-DC - 1941 Mobile Wireless Router, Руководство по настройке программного обеспечения

Страница: 134 / 184

6-26
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
OL-11503-01
Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
Configuring the NM-AIC-64, Contact Closure Network Module
Configuring an Analog Alarm as a Discrete Monitoring Current
enable
config terminal
alarm 58
description "east door"
discrete current-loop 0.0 3.2 5.9
exit
Configuring an Analog Alarm as a Discrete Monitoring Voltage
enable
config terminal
alarm 58
description "backup battery"
discrete voltage 9.0 high
exit
Configuring an Analog Alarm to Act Like a Discrete Alarm (Minimal Configuration Method)
enable
config terminal
alarm 59
discrete
exit
Configuration Tasks
See the following sections for configuration tasks for the AIC feature. Each task in the list is identified
as either required or optional:
•
Configuring the AIC, page 6-26 (required)
–
Entering Alarm Configuration Mode and Configuring the AIC IP Address, page 6-27
– Configuring the IP Route to the AIC, page 6-27
•
Configuring the NOC IP Address, page 6-30 (optional)
• Configuring Alarms, page 6-30 (optional)
Configuring the AIC
Cisco IOS commands are used for configuring the AIC IP address and the IP routing to the AIC NM.
After the IP address and the IP routing are set, alarm configurations can then be set up with either TL1
or the AIC command-line interface. See the
“Configuring the NOC IP Address” section on page 6-30 or
the “Configuring Alarms” section on page 6-30 for more information.
The following sections describe how to configure the AIC IP address and the IP Routing to the AIC NM.