Cisco Linksys WAP4410N, Руководство пользователя

Страница: 40 / 88

WAP4410N User Guide 35
The Administration - Diagnostic Tab
Configuring the Wireless-N Access Point
Change these settings as described here and click Save Settings to apply your changes, or click
Cancel Changes to cancel your changes. Help information is displayed on the right-hand side
of the screen, and click More for additional details.
The Administration - Diagnostic Tab
On this screen you can use the Wireless Access Point to perform a Ping. The activity can be
useful in solving network problems.
Ping Test
• IP or URL Address —Enter the IP address you wish to ping. The IP address can be on
your LAN, or on the Internet. Note that if the address is on the Internet, and no
connection currently exists, you could get a Timeout error. In that case, wait a few
seconds and try again.
• Packet Size —Enter the size of the packet.
• Times to Ping —Select the desired time from the list.
• Start to Ping —Click this button to start the ping procedure.
Help information is displayed on the right-hand side of the screen.
The Administration - Factory Default Tab
On this screen you can restore the Access Point’s factory default settings.
Factory Default
Note any custom settings before you restore the factory defaults. Once the Access Point is reset,
you will have to re-enter all of your configuration settings.
• Restore Factory Defaults —To restore the Access Point's factory default settings, click
the Yes radio button. Then, click Save Settings . Your Access Point will reboot and come
back up with the factory default settings in a few seconds.
Click Save Settings to apply your change, or click Cancel Changes to cancel your change. Help
information is displayed on the right-hand side of the screen.
The Administration - Firmware Upgrade Tab
On this screen you can upgrade the Access Point’s firmware. Do not upgrade the firmware
unless you are experiencing problems with the Access Point or the new firmware has a feature
you want to use.
Firmware Upgrade
Before you upgrade the Access Point’s firmware, note all of your custom settings. After you
upgrade its firmware, you will have to re-enter all of your configuration settings. To upgrade the
Access Point’s firmware: