25
Figure 26
Tightening the Velcro Strap
10
Powering On the Cisco IAD
This section provides the procedure for powering on your Cisco IAD2430 router.
Caution
Do not use AC and DC power at the same time.
If you do, the unit stops operating, and you must reboot it with
only a single power source.
Checklist for Power-On
You can power on the Cisco IAD2430 series IADs if it meets these requirements:
•
The chassis is securely mounted.
•
Power and interface cables are connected.
Power-On Procedure
Perform this procedure to power on your Cisco IAD2430 series IADs and verify that it completes its initialization and self-test.
To power on the Cisco IAD, follow these steps:
Step 1
Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, and no parity.
Step 2
Move the Cisco IAD power switch to the ON position (Cisco IAD2430 through Cisco IAD2432 IADs only).
The green LED next to the auxiliary (AUX) port should come on and the fan should operate. If this does not happen,
see the power-on procedure in the
Cisco IAD2430 Series Integrated Access Device Hardware Installation Guide
.
For the Cisco IAD2435 IAD, plug in the external power supply (see Figure 24).
281203
IAD2435-8FXS
FastEthernet
WAN
0/1
0/0
T1/E1
FXS
