16
Figure 14
Mounting-Screw Slots for Wall-Mounting the Cisco IAD2435 IAD
The following conditions must be met when you mount the router:
•
Because you will use the LEDs as status and problem indicators, the LEDs on the front panel must face upward and must
be easily visible.
•
The back panel must face downward to reduce strain on the cable connections.
•
The power supply must rest on a horizontal surface such as the floor or a table. If the power supply is not supported, it
could place strain on the power supply cable and cause it to disconnect from the connector on the router back panel.
To wall-mount a Cisco IAD2435 IAD, follow these steps:
Step 1
Secure two screws 7 inches (17.78 centimeters) apart into a wall and 5/32 inch (0.40 centimeter) from the wall.
Step 2
Hang the router on the screws as shown in Figure 15.
Step 3
Place the power supply on a horizontal surface.
1
Rubber feet
2
Mounting-screw slots
231984
1
1
1
1
2
2
