Purpose
Command or Action
Configures the remote-management IP address for the
vNIC gateway interface for the virtual services container.
guest ip address remote-mgmt-ipv4-addr
Example:
Router(config-virt-serv-intf) guest ip address
172.25.29.236
Step 13
Exits virtual services interface configuration mode and
enters virtual services configuration mode.
exit
Example:
Router(config-virt-serv-intf)# exit
Step 14
Activates the
csr_mgmt
virtual services container.
activate
Example:
Router(config-virt-serv)# activate
Step 15
Exits virtual services configuration mode and enters global
configuration mode.
end
Example:
Router(config-virt-serv)# end
Step 16
Creates an IP route that maps to the virtual port group. Use
the same IP address that was configured using the
guest
ip address
command.
ip route ip-address subnet-mask virtualportgroup
virtual-port-group-number
Example:
Router(config)# ip route 172.25.29.236
255.255.255.255 VirtualPortGroup0
Step 17
Enabling Remote Management by the Cisco Prime Network
Services Controller Host
The Cisco Prime Network Services Controller is unsupported using Cisco IOS XE Denali 16.3.1 or later,
on the Cisco CSR 1000v.
Note
The Cisco Prime Network Services Controller control point agent (CPA) is used to manage the interface
between the Cisco CSR 1000v and the Cisco Prime Network Services Controller host. The Cisco Prime
Network Services Controller CPA must be activated on the Cisco CSR 1000v before Cisco Prime Network
Services Controller can be used to remotely manage the router.
You must use the Cisco IOS XE CLI to manually activate the Cisco Prime Network Services Controller CPA
in the following situations:
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
292
Configuring Support for Remote Management by the Cisco Prime Network Services Controller
Enabling Remote Management by the Cisco Prime Network Services Controller Host
