SUMMARY STEPS
1.
enable
2.
Use one of the following commands to copy a file from a server to bootflash memory:
•
copy tftp bootflash:
•
copy rcp bootflash
3.
When prompted, enter the IP address of the TFTP or RCP server:
4.
When prompted, enter the filename of the Cisco IOS software image to be installed:
5.
When prompted, enter the filename as you want it to appear on the router. Typically, the same filename
is entered as was used in the previous step.
6.
If an error message appears that says,
“
Not enough space on device,
”
do the following:
7.
If the error message does not appear, enter
no
when prompted to erase the bootflash memory before
copying:
DETAILED STEPS
Step 1
enable
Use this command to enter privileged EXEC mode. Enter your password if prompted:
Example:
Router>
enable
Password:
<password>
Router#
Step 2
Use one of the following commands to copy a file from a server to bootflash memory:
•
copy tftp bootflash:
•
copy rcp bootflash
Example:
Router#
copy tftp bootflash:
Step 3
When prompted, enter the IP address of the TFTP or RCP server:
Example:
Address or name of remote host []?
10.10.10.2
Step 4
When prompted, enter the filename of the Cisco IOS software image to be installed:
Example:
Source filename ? csr1000v-universalk9.03.10.00.S.153-3.S-ext.SPA.bin
The filename is case
sensitive.
Note
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
203
Upgrading the Cisco IOS XE Software
Using TFTP or Remote Copy Protocol to Copy the System Image into Boot Flash Memory
