Cisco Catalyst C-ANT9103 Series, Руководство пользователя

Страница: 22 / 28

22
Cisco Catalyst 2.4 GHz and 5/6 GHz Dual-Band Polarization-Diverse Directional Patch Antenna (C-ANT9103=)
Mounting on a Pole or Mast
Note
The pole or mast must be rigid enough to hold the weight of an antenna along with the associated forces
produced by wind loads. In addition, the mast must be structurally strong enough to withstand the
clamping force of the hose clamps.
Step 1
Determine the mounting location for the antenna on the pole or mast.
Step 2 Position and mount the mounting flange bracket on to the pole or mast using the hose clamps provided
in the kit. The hose clamps should pass through the slots on the free mounting flange bracket.
One of the two required articulating mount flange brackets come attached to the back of the antenna (see Figure 1 ). The
other flange bracket, included in the kit, is the one used in this step.
Step 3 Tighten the hose clamps only to the extent that they can hold the flange bracket and the antenna in place
until the antenna is positioned at its final position. Use a slotted screwdriver to tighten the screws on the
hose clamps.
Step 4
Assemble the antenna and bracket to the flange bracket. See Figure 5 .
Step 5 Position the antenna, mounting bracket, and hose clamps on the mast. See Figure 11 for reference.
Step 6
Tighten the hose clamps until the antenna is fully secure on the mast. Ensure that the antenna cannot
rotate about the mast.
Step 7 After the antenna is secured on the mast, adjust the azimuth (side-to-side position) and elevation
(up-and-down position) of the antenna. Loosen the adjustment pivot bolts slightly to allow for
adjustment.
Azimuth angle can be adjusted ±60 degrees ( Figure 8 ) and elevation can be adjusted ±60 degrees ( Figure 9 ).
You can use the azimuth and elevation markings on the articulating mounting arm and the flange brackets as a guide.
See
Figure 7 .
Step 8 After you adjust the antenna position, tighten the adjustment bolts. Tighten all the bolts to not more than
30 lbf.in. (3.4 Nm).
Step 9
Connect the antenna’s 8-DART plug to the access point.
For the recommended cable type, see the “Recommended Cable” section on page 26 .