Cisco Catalyst C-ANT9103 Series, Руководство пользователя

Страница: 13 / 28

13
Cisco Catalyst 2.4 GHz and 5/6 GHz Dual-Band Polarization-Diverse Directional Patch Antenna (C-ANT9103=)
Installing the Antenna
You can install the antenna on a wall or ceiling (must be a flat surface), or on a pole with a minimum diameter of 2 inches
(5.08 cm) and a maximum diameter of 5 inches (12.7 cm).
To install the antenna:
Step 1
Decide on a mounting location. See the “Deciding on a Mounting Location” section on page 13 .
Step 2 Ensure that you have the requisite tools and fasteners ready. See the “Tools and Equipment Required”
section on page 14 .
Step 3
Proceed with mounting the antenna. When mounting the antenna, assemble the bracket hardware,
connect the antenna and bracket to the mounting surface, and adjust the antenna orientation.
The mounting options available are:
a. Mounting on a Wall or Ceiling Using Articulating Bracket, page 15
b.
Mounting Directly on a Wall Through Mounting Holes on the Antenna, page 21
c. Mounting on a Pole or Mast, page 22
d.
Mounting on a Wall, Ceiling or Mast with AP Mounted Directly on Antenna, page 24
Step 4 (Optional) Paint the antenna. See the “Painting the Antenna” section on page 26 .
Deciding on a Mounting Location
The antenna should be mounted clear of any obstructions to the side or front of the enclosure, which contains the
radiating elements. Keep in mind that this antenna should be aimed at the intended coverage area. Therefore, you should
mount the antenna such that the desired mechanical tilt is achieved. If possible, mount the antenna near the access point
so that you can use the shortest possible connecting cables.
Caution For outdoor installations, install the antenna with cables exiting downward. This will help prevent water
from accumulating around the cable exit points.