26 Replacing the Chassis Interface (CI) Board in the Cisco 7500 Series Chassis
Replacing the CI in the Cisco 7513
Step 3
Carefully guide the cover up and away from the chassis.
Note
Depending on the replacement procedures you need to perform, refer to the appropriate
sections, and then to replace the cover, proceed to Step 4, which follows.
Step 4
To replace the cover, carefully guide the cover over the ten screws. (See Figure 16.)
Step 5
Align the cover; then tighten all ten screws that secure it to the chassis.
This completes the backplane maintenance cover removal and replacement procedure.
Removing and Replacing the CI
The CI (shown in Figure 17) provides environmental monitoring and logic functions for the Cisco
7513.
Figure 17
Chassis Interface (MAS-7500CI=)
Note
Replace the CI only if it fails. This procedure assumes to have already removed the chassis
cover panels and backplane maintenance cover. If not, refer to the appropriate procedures in this
section to remove these items.
H2877
Chassis interface
Standoff
screw holes
Standoff
screw holes
