47.00918100000000E04FACB401.00100DAACC41.01
ATM(lane-config-database)# default-name default
ATM(lane-config-database)# ^Z
ATM# show lane database
LANE Config Server database table 'LANE_Backbone'
default elan: default
elan 'default': un-restricted
server 47.00918100000000E04FACB401.00100DAACC41.01 (prio 0)
Verifying the LANE Setup
Once you have set up the LECs on the subinterfaces of an ATM module, you can display their ATM
addresses by using the following command in privileged EXEC mode:
Command
Purpose
Router#
show
lane
Displays the LES, BUS, and LEC ATM addresses.
The command output shows all the subinterfaces configured for LANE. For each subinterface, the
command displays and labels the ATM addresses that belong to the LES, BUS, and the LEC.
When you look at each ATM address, confirm the following items:
•
The prefix is the one you set up on the switch.
•
The end-system identifier field reflects the base address of the pool of MAC addresses assigned to the
ATM interface plus a value that represents the specific LANE component.
•
The selector byte is the same number as the subinterface (converted to hexadecimal).
Enter the show lane EXEC command on each Catalyst 5000 series switch to verify the LANE setup before
you set up the LECs on the next Catalyst 5000 series switch. Print the display or make a note of these ATM
addresses so that you can use it when you set up the LECS database. At this point in the configuration
process, the LECs are not normally operational.
Monitoring and Maintaining LANE Components
After configuring LANE components on an interface or any of its subinterfaces, you can display their status
on a specified subinterface or on an ELAN. To show LANE information, issue the following commands in
privileged EXEC mode:
Command
Purpose
Router#
show
lane
[
interface
atm
0
[subinterface-number
|
name
elan-name
]] [
brief
]
Displays the global and per-VCC LANE
information for all the LANE components and
ELANs configured on an interface or any of its
subinterfaces.
Router#
show
lane
bus
[
interface
atm
0
[subinterface-number
] |
name
elan-name
] [
brief
]
Displays the global and per-VCC LANE
information for the BUS configured on any
subinterface or ELAN.
Verifying the LANE Setup
Configuring Fast SSRP for Redundant LANE Services
27