10
This completes the procedure for installing the cable-management brackets on a Cisco ASR 1002-F Router for a chassis
rack-mount configuration
.
Chassis Ground Connection Installation
Before you connect power or turn on power to your router, you must provide an adequate chassis ground (earth) connection
for the Cisco ASR 1002-F Router. The two-hole chassis ground lug and the respective screws that ship with your Cisco
ASR 1002-F Router.
The following tools, equipment, and supplies are necessary to connect the system ground to the chassis:
•
Phillips screwdriver
•
Dual-lug chassis ground component (two) and respective screws (four) (shipped with the accessory kit)
•
Grounding wire
See
Figure 7
for the location of the chassis ground connector on the Cisco ASR 1002-F Router.
Figure 7
Cisco ASR 1002-F Router Ground Connector Location and eUSB Panel Door
Step 1
Use the wire stripper to strip one end of the AWG #6 wire approximately 0.75 inches (19.05 mm).
Step 2
Insert the AWG #6 wire into the wire receptacle on the ground lug.
Step 3
Use a manufacturer’s recommended crimping tool to carefully crimp the wire receptacle around the wire; this step is
required to ensure a proper mechanical connection.
1
Cisco ASR 1002-F Router ground connector location
1
eUSB panel door
274501
SPA-4X
OC3-POS
S
T
A
T
U
S
0
1
2
3
C
/A
A
/L
C
/A
A
/L
C
/A
A
/L
C
/A
A
/L
0
1
2