34
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
78-17634-01
Manually Configuring Controller Information Using the Lightweight Access Point CLI
Configuring Controller Information
Use these Exec mode CLI commands to manually configure controller information on a new access
point:
lwapp ap ip address
<
IP address
> <
subnet mask
>
lwapp ip default-gateway
IP-address
lwapp controller ip address
IP-address
lwapp ap hostname
name
Where
name
is the access point name on the controller.
Note
The default Enable password is
Cisco
.
Clearing Manually Entered Controller Information
When you need to move your access point to a different location in your network, you must clear the
manually entered controller information to allow your access point to associate with a different
controller.
Note
This command requires the controller-configured Enable password to enter the CLI EXEC mode.
You can use these EXEC mode CLI commands to clear or remove the manually entered controller
information:
clear lwapp ap ip address
clear lwapp ip default-gateway
clear lwapp controller ip address
clear lwapp ap hostname
Manually Resetting the Lightweight Access Point to Defaults
You can manually reset your lightweight access point to default settings using this EXEC mode CLI
command:
clear lwapp private-config
Note
This command requires the controller configured Enable password to enter the CLI EXEC mode.
