A-3
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal Antennas - Quick Start Guide
78-17146-01
Appendix A Planning Notes
Physical Security
Regardless of the mounting type selected, the AP can be secured with a Kensington MicroSaver Security
Cable. If required, use any MicroSaver Security Cable to attach either side of your AP to a solid beam,
pipe, or support.
FCC Statements for Cisco Aironet 1000 Series Lightweight Access Points
FCC Statements for Cisco Aironet 1000 Series Lightweight Access Points
This section includes the following FCC statements for the Cisco Aironet 1000 Series lightweight access
point:
•
Class A Statement, page A-3
•
RF Radiation Hazard Warning, page A-3
•
Non-Modification Statement, page A-3
•
External Antennas, page A-4
•
Deployment Statement, page A-4
Class A Statement
Class A Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense. [cfr reference 15.105]
RF Radiation Hazard Warning
RF Radiation Hazard Warning
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location
such that the antenna of the device will be greater than 20 cm (8 in.) from all persons. Using higher gain
antennas and types of antennas not covered under the FCC certification of this product is not allowed.
Installers of the radio and end users of the Cisco Wireless LAN Solution must adhere to the installation
instructions provided in this manual.
Non-Modification Statement
Non-Modification Statement
Use only the supplied internal antenna, or external antennas supplied by the manufacturer. Unauthorized
antennas, modifications, or attachments could damage the badge and could violate FCC regulations and
void the user’s authority to operate the equipment.
