Installation and Configuration
Mounting the Access Points
12
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
7817146-01
Figure 9
Attaching the Mounting Screws and Spring Washers to the AP
2.
Copy the MAC address(es) from the label(s) on the AP onto the corresponding location on the map.
MAC addresses have the format 00xxxxxxxxxx.
3.
You have already attached the flush-mount bracket to the wall in “
Preparing Mounting Locations
”
.
4.
Slide the screws into the keyhole slots on the mounting bracket as shown in the following figure.
Note
Be sure the side of the AP with the door is facing away from the wall (flat Side A toward the inside of
the building). This ensures that the correct antenna is facing the building, and makes future upgrades
easier.
Note
If the screws do not securely hold the bracket, remove the AP and adjust the screws until they securely
hold the bracket.
Figure 10
Attaching the AP to the Flush-Mount Bracket
5.
Attach the cables to the sides of the AP.
135667
A. Screws and spring washers
B. Completed assembly
135669
