4-5
Cisco 819 Integrated Services Router Hardware Installation Guide
OL-23125-02
Chapter 4 Initial Configuration
Verifying the Initial Configuration
Step 12
Respond to the following prompts. Enter
2
to save the initial configuration.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
RETURN
The user prompt is displayed.
Router>
Step 13
Verify the initial configuration. See the
“Verifying the Initial Configuration” section on page 4-5
for
verification procedures.
After the initial configuration file is created, you can use the Cisco IOS CLI to perform additional
configuration.
Verifying the Initial Configuration
To verify that the new interfaces are operating correctly, perform the following tests:
•
To verify that the interfaces and line protocol are in the correct state—up or down—enter the
show
interfaces
command.
•
To display a summary status of the interfaces configured for IP, enter the
show ip interface brief
command.
•
To verify that you configured the correct hostname and password, enter the
show configuration
command.
After you complete and verify the initial configuration, you can configure your Cisco router for specific
functions.
Содержание 819 series
Страница 6: ...Contents 4 Cisco 819 Integrated Services Router Hardware Installation Guide OL 23125 02 ...
Страница 11: ...9 Cisco 819 Integrated Services Router Hardware Installation Guide OL 23125 02 Preface ...
Страница 13: ...11 Cisco 819 Integrated Services Router Hardware Installation Guide OL 23125 02 Preface ...
Страница 18: ...16 Cisco 819 Integrated Services Router Hardware Installation Guide OL 23125 02 Preface ...
