Cisco 7911, Руководство пользователя

Страница: 15 / 76

Connecting Your Phone
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified CallManager 5.1 (SCCP and SIP) 7
Adjusting the Handset Rest
When you connect your phone, you might want to adjust the handset rest to ensure that the receiver
will not slip out of the cradle. See the table below for instructions.
Registering with TAPS
After your phone is connected to the network, your system administrator might ask you to
auto-register your phone using the Tool for Auto-Registered Phones Support (TAPS). TAPS might be
used either for a new phone or to replace an existing phone.
To register with TAPS, pick up the handset, enter the TAPS extension provided by your system
administrator, and follow the voice prompts. You might need to enter your entire extension, including
the area code. After your phone displays a confirmation message, hang up. The phone will restart.
Headset Information
To use a headset, make sure the handset is disconnected, then connect the headset to the Handset port
on the back of your phone.
Depending on headset manufacturer’s recommendations, an external amplifier may be required. Refer
to headset manufacturer’s product documentation for more information.
1 Set the handset aside and pull the square plastic tab from the handset rest.
2 Rotate the tab 180 degrees.
3 Slide the tab back into the handset rest. An extension protrudes from the top of the rotated tab.
Return the handset to the handset rest.
1 2 3
77354