3-10
Catalyst 6500 Series Ethernet Modules Installation Guide
OL-6265-03
Chapter 3 Installing Ethernet Switching Modules
Removing an Ethernet Switching Module
Removing an Ethernet Switching Module
This section describes how to remove an Ethernet switching module from the Catalyst 6500 series switch
chassis.
Caution
During this procedure, wear grounding wrist straps to avoid ESD damage to the module.
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments.
Statement 1051
To remove a module from the chassis, perform these steps:
Step 1
Attach an ESD grounding strap to your wrist and to ground.
Note
If you are unsure about the correct way to attach an ESD grounding strap, see the
“Attaching
Your ESD Grounding Strap” section on page C-1
for instructions.
Step 2
Disconnect any network interface cables attached to the module.
Step 3
Verify that the captive installation screws on all of the modules in the chassis are tight.
Note
This step ensures that the space created by the removed module is maintained. If the captive
installation screws are loose, the EMI gaskets on the installed modules will push the modules
toward the open slot, reducing the opening size and making it difficult to remove the module.
Step 4
Loosen the two captive screws on the module. Make sure that the two captive screws are completely
unscrewed from the chassis.
Step 5
Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the
following two sets of steps:
Horizontal slots
a.
Place your thumbs on the left and right ejector levers and simultaneously rotate the levers outward
to unseat the module from the backplane connector.
b.
Grasp the front edge of the module and slide the module part of the way out of the slot. Place your
other hand under the module to support the weight of the module. Do not touch the module circuitry.
Vertical slots
a.
Place your thumbs on the ejector levers located at the top and bottom of the module, and
simultaneously rotate the levers outward to unseat the module from the backplane connector.
b.
Grasp the edges of the module, and slide the module straight out of the slot. Do not touch the module
circuitry.
Содержание 6513 - Catalyst Switch
Страница 6: ...Contents vi Catalyst 6500 Series Ethernet Modules Installation Guide OL 6265 03 ...
Страница 14: ...xii Catalyst 6500 Series Ethernet Modules Installation Guide OL 6265 03 Preface Conventions ...
Страница 254: ...Index IN 16 Catalyst 6500 Series Ethernet Modules Installation Guide OL 6265 03 ...