2-22
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7
OL-17013-01
Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU
How to Perform the Initial MCU Configuration
•
Enter the letter for the set of parameters that you want to configure.
•
Enter
Q
to save your changes and allow the device to complete the boot process.
This information appears in the SCCP Protocol Configuration dialog box in the Administrator interface.
In this dialog box, you can configure the MCU to support Cisco Unified Communications Manager as
an SCCP conference bridge
Changing the Global User Name and Password
You can change the global user name and password that the MCU uses. You use this user name and
password to access the configuration web page for the MCU, and is required for these tasks:
•
Starting a Telnet session to monitor the MCU
•
Upgrading the MCU software
•
Uploading Interactive Voice Response (IVR) messages to MCU configuration memory
The default global user name is
admin
. The default password is <null>.
Procedure
Step 1
Start a terminal emulator session as described in the
“Setting the IP Address” section on page 2-18
.
Step 2
At the prompt, enter
P
.
Step 3
At the Enter User name prompt, enter the name that you want to use as the global user name and press
Enter
.
Step 4
At the Password prompt, enter the password that you want to use and press
Enter
.
The network configuration Main menu appears.
Step 5
At the network configuration Main menu, do one of the following:
•
Enter the letter for the set of parameters that you want to configure.
•
Enter
Q
to save your changes and allow the device to complete the boot process.
Connecting the Cisco Unified Videoconferencing 3545 MCU to the LAN
Procedure
Step 1
Connect the supplied LAN cable from your network switch to the 10/100BaseT Ethernet port on the front
panel of the MCU unit. The 10/100BaseT port accepts an RJ-45 connector.
Step 2
Turn on the power to the MCU unit.
