4
5
Connect the appropriate network module
cable(s) to your network.
For information on connecting network modules,
refer to the Cisco Network Modules Hardware
Installation Guide included in your router package.
2
Connect Cables
SEE MANUAL BEFORE INSTALLATION
SERIAL 1
SERIAL 0
CONN
CONN
WIC
2A/S
SEE MANUAL BEFORE INSTALLATION
SERIAL 1
SERIAL 0
CONN
CONN
WIC
2T
AUX
CONSOLE
ETHERNET 0 ACT
LINK
100-240V– 1A
50/60 Hz 47 W
MODEMS
EN
IN USE
IN USE
16AM
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Installing a Network Module
Use this procedure, if required, to install an 8- or
16-port analog modem network module in a
Cisco 2610 router.
Look for a network module in the slot labeled 1 on
the left-rear of the router. If there is an analog
modem network module already installed, continue
to cable the router as described in this guide.
If you need to install an analog modem network
module, follow this procedure:
1
Use a Phillips screwdriver to remove the screws
that hold the metal plate over the network
module slot cover and remove the metal
covering plate.
2
Hold the network module by the handle and line
the module up with the guides on either side of
the slot.
3
Push the module into place until the edge
connector is securely seated in the connector on
the motherboard. Ensure that each of the
module’s captive screws line up with their hole in
the chassis.
4
Secure the captive mounting screws into the
holes of the chassis using a Phillips screwdriver.