Cisco 1750, Руководство по установке

Страница: 46 / 84

Recovering a Lost Password
iv
Cisco 1750 Router Hardware Installation Guide
78-6169-02
Resetting the Router
Follow these steps to reset the router:
Step 1
Do one of the following:
• If break is enabled, go to Step 2.
•
If break is disabled, turn the router off, wait 5 seconds, and turn it on again.
Within 60 seconds, press the
Break key. The terminal displays the
ROM monitor prompt. Go to Step 3.
Note
Some terminal keyboards have a key labeled Break. If your
keyboard does not have a Break key, refer to the
documentation that came with the terminal for instructions
on how to send a break. To send a break in Windows
HyperTerminal, enter Ctrl-Break.
Step 2
Send a break. The terminal displays the following prompt:
rommon 2>
Step 3
Enter confreg 0x142 to reset the configuration register:
rommon 2> confreg 0x142
Step 4
Initialize the router by entering the reset command:
rommon 2> reset
The router resets, and the configuration register is set to 0x142. The router boots
the system image in Flash memory and displays the following:
--- System Configuration Dialog ---
Step 5
Enter no in response to the prompts until the following message is displayed:
Press RETURN to get started!
Step 6 Press Return . The following prompt appears:
Router>