Cirrus Garmin GFC 700, Руководство по обслуживанию

Страница: 23 / 42

CIRRUS A
IRPLANE
M
AINTENANCE
M
ANUAL
C
HAPTER
22-10: GFC 700 A
UTOMATED
F
LIGHT
C
ONTROL
S
YSTEM
MODELS SR22
AND
SR22T M
AINTENANCE
P
RACTICES
23
(c) Perform Adjustment/Test - GSM 86 Pitch Servo Mount Bridle Cable Tension.
(Refer to 22-10)
(d) Connect pitch servo plug to socket.
(e) Reset AP SERVOS circuit breaker.
(f) Perform Operational Test - GFC 700 Autopilot. (Refer to 22-10)
(g) Serials w/ Air Conditioning: Install condenser. (Refer to 21-50)
(h) Install access panel CF5. (Refer to 6-00)
(5) Adjustment/Test - GSM 86 Pitch Servo Mount Bridle Cable Tension
(a) Acquire necessary tools, equipment, and supplies.
(b) Remove access panel RE1. (Refer to 6-00)
(c) Using rigging lockout tool and pin, lockout elevator empennage bellcrank.
(d) Using tensiometer, verify elevator control cable tension. If elevator control cable
tension falls outside specified tolerance, perform Adjustment/Test - Elevator
System Rigging.
(Refer to 27-30)
(e) On servo capstan, position bridle cable stop-ball at 9 o’clock position (stop-ball
at forward side of capstan in the capstan recess).
(f) Ensure approximately two and one-half wraps of bridle cable exist around
capstan and that stop-ball is in center of cable wrap when cable is at center of
travel.
(g) Ensure that stop-ball can not become disengaged from capstan recess or that
bridle cable exit length can not exceed full groove length of capstan.
•
NOTE
•
Use a ratcheting open-end wrench and socket for tight-
ening bridle cable clamp assembly to elevator cable.
Description P/N or Spec. Supplier Purpose
Tensiometer BT-33-75D Kent Moore Cable tension
determination.
Rigging Lockout Tool 14905-001 Cirrus Design Lockout elevator
bellcrank.
3/16” Lockout Pin - Any Source Lockout elevator
bellcrank.
23 Dec 2016